- Model NO.: JL1000
- Tank Capacity: 2.5
- Control: Wireless Remote Control
- Output Distance: 7m
- Certification: CE, RoHS
- G.W: 9kg
- Specification: 69*34*39
- HS Code: 8424899990
- Smoke Output: 4000
- Power: 1000
- Fuel Consumption Rate: 30/L
- Warm up Time: 5min
- Size: 69*34*39
- Trademark: JBL
- Origin: China
1)innovative process heatiing systems,injection time more durable,a sing injection up to 13seconds continuous injection interval is very short;
2)smoke and dried over anhydrous gas,more environmentally and friendly
3)simplified remote control and point operating mode
4)built-in super signal receiving module,farther than the conventional remote concrol (up to 50 meteers)
5)smooth pipeline structure
6)the bubble inside has fog,can product bubble and fog together
Pre-heating time: 5Mins
Oil Tank capacity:2.3L/h
Oil consumption rate:30m/L
Timing and quantitative controller:√
After receiving the bubble smoke machine, open the package and check carefully whether the machine is damaged or the accessories are lost, if problems found, please contact the distributor.
Put the machine on a level plane and then pour 0.7L bubble water into the tank of the machine and pour 2L fog oil into the oil tank. Turn the two switch at "On".Connect the power supply.
Don't add tinder liquid such as oil, gas, perfume and etc. in fog machine.
Pay more attention to all notices sign and operation instructions on all machines.
Please use the high quality fog liquid recommended by distributors. Bad quality fog liquid may get blast or spray oil.
Often check whether there has enough fog liquid.
Get out all fog liquid before transport or post.
Don't eat fog liquid otherwise to see the doctor immediately. Use clean water to wash skin and eyes once fog liquid touches them.
1. Take away all pack material especially the spray mouth.
2. Set in the horizontal direction and open the cover of liquid can.
3. Add high quality fog liquid in the machine and screw the cover of liquid can. Bad quality fog liquid will damage fog machine.
4. Plug the plug of remote console in the socket of the back of machine.
1. Connect the power line to the power socket with earth line. Turn the switch at "On" and the machine heat. Smoke and bubble machine begins heating, until the completion of heating, the green light on the remote control. Simple to use, with water to wash the plastic tray and turntable, then poured into special bubble solution, connected to the controller, through the power, (you can switch between automatic control and remote control selection).
2. Press red key, the machine will spray fog (Press it as long as you need).
3. Can set the machine at a high place (with hanger) or on the ground. Do not spray fog to people directly and the lean angle should less than 15°
4. Often check whether there has enough fog liquid in machine. The operation will make big damage to the machine if there has no fog liquid.
5. If the fog is small, blue has noise or there has no fog, please power off and check fog liquid, fuse, the connector of remote console and power plug. If the problem could not be solved after check these parts, please stop check and send it back to distributor for repair.
Please clean the fog machine timely to avoid the damage of spare parts and decrease the repair charge.
Don't make the fog machine be dirty. Screw the cover of liquid can after add fog liquid.
After about 40 hours continually use, please use 80% distilled water and 20% vinegar to clean the dirty in refractory pipe.
Disassemble the spray mouth and use vinegar to clean it to keep expedite before heat.
Reequip the spray mouth after cool and add fog liquid for next use.